RP TYPE 4 ELT HOT APPLIED SEALANT is formulated with selected asphaltic resins, synthetic polymeric rubber, plasticizers, stabilizers, and a blend of organic, reinforcing fillers. This flexible material is a hot applied, one-part sealant that provides excellent results under extremely varying conditions. RP TYPE 4 ELT is the perfect joint and crack sealant for large scale projects experiencing maximum joint movement in the coldest of temperatures.
- Superior bonding characteristics
- High resiliency and weather resistance
- Excellent results throughout freeze and thaw cycles
RP TYPE 4 ELT meets all requirements of: ASTM D6690 Type IV, AASHTO M324 Type IV, and ASTM D3405 Modified.
|Recommended Pour Temperature||370 - 390 °F|
|Maximum Safe Heating Temperature||410 °F|
|Penetration at 25 °C||110 – 150|
|Penetration at -18 °C||40 min.|
|Resilience||60 % min.|
|Bond, -29 °C/200% Ext.||Passes 3 cycles|
|Flow at 140 °F||3.0 mm max.|
Use an agitated, oil-jacketed unit that has separate temperature gauges for both the sealant and the heat transfer fluid. Take the plastic bag of sealant and load into the kettle one at a time. Melt only enough material for the day’s activities. Once melted, additional material can be added as needed. Material can be safely reheated within the sealants service life. NOTE: Prolonged heating of the sealant above the maximum safe heating temperature may cause it to gel in the kettle.
To facilitate proper adhesion, the joint or crack should be dry and clear of any dirt, dust, or other contaminates. Substrate and ambient temperatures must be 40 °F or above. Proper sizing of the joint will cause the maximum extension/compression to not exceed 50% of the width. Joints or random cracks of ¼” or less are difficult to properly clean prior to applying the sealant.
The service life when heated to application temperature is approximately 12 hours. Adding fresh material to the melter as sealant is being used will extend the service life. Product shall be agitated during installation. Any material that has exceeded the service life should be removed from the melter and discarded.
|Coverage Width||Coverage Depth||Coverage Pounds/100 Lineal Feet|
35 lbs. per unit - 60 Units per Pallet - 2100 lbs. per Pallet30 lbs. per NO BOX unit - 65 Units per Pallet - 1950 lbs. per Pallet