RP DF PROSTRETCH B is formulated with selected asphaltic resins, synthetic polymeric rubber, plasticizers, stabilizers, and a blend of organic, reinforcing fillers. This construction grade material is a hot applied, one-part sealer that provides excellent results under extremely varying conditions. RP DF PROSTRETCH B is perfect for use in applications that are susceptible to tracking and picking up, such as pedestrian foot traffic and vehicle power steering in high temperature conditions.
• High toughness and durability
• Fast melt, easy pour, fast set
• Passes multiple freeze and thaw cycles
RP DF Prostretch B meets the requirements of local municipal codes.
|Recommended Pour Temperature||370 - 390 °F|
|Maximum Safe Heating Temperature||410 °F|
|Recommended Extended Heating||6 Hours|
|Penetration at 25 °C||45 max.|
|Softening Point||200 °F min.|
|Softening point||3.0 mm max.|
|Resilience||40 % min.|
Use an agitated, oil-jacketed or direct fired unit that has separate temperature gauges for both the sealant and the heat transfer fluid. Take the plastic bag of sealant and load into the kettle one at a time. Melt only enough material for the day’s activities. Once melted, additional material can be added as needed. Material can be safely reheated within the sealants service life. NOTE: Prolonged heating of the sealant above the maximum safe heating temperature may cause it to gel in the kettle.
To facilitate proper adhesion, the joint or crack should be dry and clear of any dirt, dust, or other contaminates. Substrate and ambient temperatures must be 40 °F or above. Proper sizing of the joint will cause the maximum extension/compression to not exceed 50% of the width. Joints or random cracks of ¼” or less are difficult to properly clean prior to applying the sealant.
The service life when heated to application temperature is approximately 12 hours. Adding fresh material to the melter as sealant is being used will extend the service life. Product shall be agitated during installation. Any material that has exceeded the service life should be removed from the melter and discarded.
|Coverage Width||Coverage Depth||Coverage Pounds/100 Lineal Feet|